Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Cock Coil ADS

Originally Posted by Schlong7
I can’t wait to get one. Can it be worn while sleeping? It seems like the purpose is to hold the BPFSL? It also looks like it’s easier to put on than an extender. I’m just curious about the coil? I’ve been checking it out for a while, thanks to Thundersplace. The sleeves look like they can replace coban for extenders, instead of having to buy it all the time.

It is pretty well universally agreed upon that you should never do any kind of PE while sleeping, no matter how “safe” you think they are. Unless waking up without your penis is on your bucket list.


Current 5.5 NBPEL x 5.75 Base EG - 5.25 MSEG 7" BPSFL

Short Term Goal 6 NBPEL x 6 MPEG

Long Term Goal 8 NBPEL x 7 MPEG (why not dream BIG?)

Schlong7

The Corkscrew can be comfortably worn 4-8 hrs depending on how you set it up. With the coils stretched further apart for more extension means less time before pain thresh holds are encountered. So the tradeoff is between length of time and intensity which at a certain point intensity is better served by hanging imo. Sleeping with the coil on is not recommended.

I use the spandex sleeve to “thread” the coil into position and then slide it off before screwing the end coils tight to secure the penis in place. The underlying Stealth Inner Wear with double layer sheath made of cotton weave fabric acts to buffer the penis shaft from contact with the coils while the silicone bead seated behind the glans makes for an excellent cushion to protect the glans while under extension.

Stealthman

Originally Posted by Schlong7
I can’t wait to get one. Can it be worn while sleeping? It seems like the purpose is to hold the BPFSL? It also looks like it’s easier to put on than an extender. I’m just curious about the coil? I’ve been checking it out for a while, thanks to Thundersplace. The sleeves look like they can replace coban for extenders, instead of having to buy it all the time.

Toxsus,

After 8 years wearing the Stealth Inner Wear I can assure you that wearing it at night for passive extension of the flaccid penis to near erect length is perfectly safe. During testing with fittings that were too tight, I have regularly been woken up by the discomfort of morning wood due to excessive constriction of the engorged size. I have countless times removed it, often is a twilight state, and simply gone back to sleep. This was again experienced during development/testing of the spandex sleeves and then again with the Retainer Bands. I now sleep with just the Inner Wear on and sometimes with the Retainer Band too.. With no discomfort at all and sleep thru the early morning erections.

However, I agree that it is more dangerous if you are using high intensity devices that can cause tissue damage within a few hours of early sleep.

Stealthman

Originally Posted by Toxsus
It is pretty well universally agreed upon that you should never do any kind of PE while sleeping, no matter how “safe” you think they are. Unless waking up without your penis is on your bucket list.

Originally Posted by StealthForMen
Toxsus,

After 8 years wearing the Stealth Inner Wear I can assure you that wearing it at night for passive extension of the flaccid penis to near erect length is perfectly safe. During testing with fittings that were too tight, I have regularly been woken up by the discomfort of morning wood due to excessive constriction of the engorged size. I have countless times removed it, often is a twilight state, and simply gone back to sleep. This was again experienced during development/testing of the spandex sleeves and then again with the Retainer Bands. I now sleep with just the Inner Wear on and sometimes with the Retainer Band too.. With no discomfort at all and sleep thru the early morning erections.

However, I agree that it is more dangerous if you are using high intensity devices that can cause tissue damage within a few hours of early sleep.

Stealthman

Toxsus,
I know right? The only thing I have heard to come close is the Phallason Forte. I hear a lot of ppl use silicone sleeves to keep the BPFSL, seldom while sleeping. Thanks for the info Stealth. This will definitely be a staple in my hanging regimen for anti-turtling.

Fitting a cock coil / corkscrew

StealthForMen]

>The Corkscrew can be comfortably worn 4-8 hrs depending on how you set it up. With the coils stretched further apart for more extension means less time before pain thresh holds are encountered. So the tradeoff is between length of time and intensity which at a certain point intensity is better served by hanging imo. Sleeping with the coil on is not recommended.

>I use the spandex sleeve to “thread” the coil into position and then slide it off before screwing the end coils tight to secure the penis in place. The underlying Stealth Inner Wear with double layer sheath made of cotton weave fabric acts to buffer the penis shaft from contact with the coils while the silicone bead seated behind the glans makes for an excellent cushion to protect the glans while under extension.

I believe perfecting the technique for filling a coil on your penis is the key to its optimum use. If we get it right I reckon we can wear it for a longer period and still get some extending / stretching. As you have admitted you cannot really get high intensity stretching with a coil because of the ductility of the lead wire. However you can still get useful extension which coupled with say a 1 lb weight of lead can provide a very useful adjunct to more intense extending with a conventional extender or after hanging. Monty makes a similar point about his PE weights and I believe he is onto something here.

Anyway to the fitting point. I fit my coil by first making sure its ID is larger than my penis. I then slip it on and then ‘screw’ it from one end so it tightens up and grips my penis. It seems to tighten in the middle first. I have to make a special effort to tighten it at the front end so I can get an extender effect. If I over tighten it soon becomes uncomfortable. If I get this right I can wear it for hours with little discomfort.

Can you explain why you believe it is beneficial to use the spandex sleeve as well as the Innerwear? Also do you have any insights in how to perfect this screwing action so we can get just the right amount of tightness where it is needed?

Austfred

I won’t do any kind of PE in my sleep and I don’t recommend anyone else do it either. That is all I am going to say about that.


Current 5.5 NBPEL x 5.75 Base EG - 5.25 MSEG 7" BPSFL

Short Term Goal 6 NBPEL x 6 MPEG

Long Term Goal 8 NBPEL x 7 MPEG (why not dream BIG?)

Austfred,

Agree, optimum comfort requires some initial experimentation to find the right balance of extension and secure fit.

The forming tube is sized to fit individual girth within a few millimetres. The spandex sleeve is required to “thread” the Corkscrew into position and then assist with pulling the glans outside of the last coil. Then simply twist the end coil or two to tighten and hold the glans in place, then remove the sleeve by pulling it out completely. Fine tune the fit with a final twist or slight pressure to clamp the end of the coil behind the glans. No twisting of the individual coils along the shaft is required using this technique.

Stealthman

Originally Posted by austfred
StealthForMen]

I believe perfecting the technique for filling a coil on your penis is the key to its optimum use. If we get it right I reckon we can wear it for a longer period and still get some extending / stretching.

Can you explain why you believe it is beneficial to use the spandex sleeve as well as the Innerwear? Also do you have any insights in how to perfect this screwing action so we can get just the right amount of tightness where it is needed?

Austfred

Corkscrew "how to wear" vid...

…is up on you tube.

Privacy info: Clicking on this image will enable content from youtube.com

Stealthman

Any review for this device?

Home Depot in Canada has these large “Gear Ties” . They are large rubber twist ties.

http://www.homedepot.com/p/Nite-Ize…11-A1/203628170

I bought the longest, 18 inches I think.

You can bend these things like a giant pipe cleaner around your unit and keep it from turtling after a session.

I wear it evenings and weekends and never overnight.

I’ve been doing some early stage experimenting with the HTW + CC combo as a clamping device. By simply wearing the CC as usual in a flaccid state, and then adding some slight arousal, a moderate clamp effect is induced. Then by gradually loosening the coil, the clamp effect continues to expand into the extra space provided by the loosening, right up until the point that you loosen the coil beyond the clamped EG.

I’m looking into using the coil as a jelq ring, set with ID just below the EG, although this seems less promising. One member (can’t remember who) got significant girth gains from a similar exercise using an O-ring. Perhaps making a smaller length coil would help with this.

I don’t think it has enough tightness to cause stress levels comparable to other clamping methods. But maybe somebody will tinker around with it and find something worthwhile.


Before 5.5" x 4.1" volume 7.3 ci ////// Now 7.4" x 4.9" volume 14.1 ci

BD, could you tether the two ends of the CC together with surgical tubing or similar to allow for some amount of uncoiling under tumescence, but the degree to which would be limited by the ‘braking’ action of the tubing under strain? Could make for a nice passive clamping gizmo that turns nocturnal erections into PE exercises.

xeno


originally: 6.5" BPEL x 5.0" EG (ms); currently: 9.375" BPEL x 6.75" EG (ms)

Hidden details: Finding xeno: a penis tale; Some photos: Tiger

Tell me, o monks; what cannot be achieved through efforts. - Siddhartha Gautama

Safely turning nocturnal erections into clamped nocturnal erections? Passive PE jackpot if I’ve ever heard of one. Would take some serious engineering though to get it to work, and safely (even a mild clamp effect could be harmful if it was sustained for long enough).

I tried CC clamping again last night, and really liked setting up the clamp effect, and then doing manual girth work on the head. I know there’s been a lot of posts over the years about targeting glans size gains, and this could be a good way to do it.


Before 5.5" x 4.1" volume 7.3 ci ////// Now 7.4" x 4.9" volume 14.1 ci

Originally Posted by BeardedDragon
Would take some serious engineering though to get it to work, and safely (even a mild clamp effect could be harmful if it was sustained for long enough).

The only way I could think of that the tubing might work was making a coil comprised of alternating segments of rubber-coated lead, and then the elastic tubing. The tubing needs some way to act on each individual coil, and all the way around each coil. How to connect them all in a smooth surfaced coil is beyond my capabilities.

Maybe I’m visualizing the suggestion wrong, but it seems any tubing that attached only to the end coils, or end tips, wouldn’t act on the central coils.


Before 5.5" x 4.1" volume 7.3 ci ////// Now 7.4" x 4.9" volume 14.1 ci

Well, another day of experimenting with cock coil clamping. I tried building a smaller coil to see if it had a good clamp effect on more of the shaft, and it does. But the clamp effect is basically the same as with the longer coils, just more of the shaft affected.

I did more work on targeting the glans. I found if I got the tightness right, I could get an extreme stretch in the glans, by kegeling blood past the coil along with pressing it past the coil with my left hand (by pressing on the internal penis behind the balls) while simultaneously pushing the coil into my pubic bone with the right hand. This caused a tremendous glans stretch feeling, as if the skin were about to burst.

Anyway, I won’t post too much more on it unless I find improvements. But the general idea is to wear the cock coil at various tightness while stimulating yourself, and look for ways to push the envelope of expansion above the coil. Very promising IMO, and generally safer than other forms of clamping in that there is a limit on the tightness one can achieve.


Before 5.5" x 4.1" volume 7.3 ci ////// Now 7.4" x 4.9" volume 14.1 ci

Top

All times are GMT. The time now is 04:49 PM.