Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

"cock coffin / constrictor".

Thanks Wajiro.

Originally Posted by marinera

*Is that correct grammatic?

Is that correct grammar?


firegoat is fully RETIRED from Thundersplace.

All injuries happen from "too much", or "too much, too soon" or "doing the exercise incorrectly".

Heat makes the difference between gaining quickly or slowly for some guys, or between gaining slowly instead of not at all for others. The ideal penis size is 7.6" BPEL x 5.6" Mid Girth. Basics.... firegoat roll How to use the Search button for best results

Originally Posted by a-unit
I will do that during my session tomorrow.

I have seen a recent decrease of 1/8” in length recently due in all likelygood to a ten week decon break, so that may skew whatever length increase is seen in the short term.

Thanks a-unit.
Since expansion seems to be such a key factor in clamping it’ll be interesting to see if the multiple clamps create more.

Originally Posted by jopa16

There HAS to be a better name for this device.

Cock cremation?


Running a Massive Co-Front.

Originally Posted by capernicus1
Sorry tnt but you’re mistaken on this.
I politely suggest you read xenos old progress thread where he describes this idea in some detail.


I am not mistaken, you are. As I posted, it worked for me. If the coffin approach works for others
than they should try it. What is the most you gained in a year? I remember xeno, and I must say,
he at times came up with whoppers. I haven’t PE’d in years since not only did I meet my goal but
surpassed it. I do not wish to gain anymore.

What worked for me may not work for you. Having gaps between clamps would not have worked
for me because I was looking for the best of both worlds and I found that forcing the first clamp as
close to the pubic bone and tighten it cause a bulb to pop out at the base of the unit which forced the clamp
closer to the pubic bone. The second clamp placed directly against the first forces more pressure
to the glands stretching the length of the penis as well, then the third makes the pressure more intense
stretching the penis even more, then the fourth. I was stretching my unit and gaining girth as well.
For me, gaping the clamps did not give me the pressure I needed, in fact, it relieved pressure.
Everybody is different. I believe I have a pic of me glued double clamp in my thread.

If you glue the clamps, use marine silicon. That shit is strong glue and can take a lot of pressure.

Originally Posted by capernicus1
Thanks a-unit.
Since expansion seems to be such a key factor in clamping it’ll be interesting to see if the multiple clamps create more.

I think, and this thought has yet to he validated, that what is happening is that my unit is being squeezed its entire length, and because of the restriction of the clamps as a constricting tube, the shaft has only the ability to move length-wise in its attempt to relieve the pressure.

It this is true then this method could be a length exercise and a way to expand the glans at the same time.


Began December 2009 at 5 7/8" length and 5" girth.

As of December 5th 2012 7 3/8" BPEL and 6 1/8" base girth.

Going for the magic 8"x6"

Originally Posted by tntjockey
I am not mistaken, you are. As I posted, it worked for me. If the coffin approach works for others
Than they should try it. What is the most you gained in a year? I remember xeno, and I must say,
He at times came up with whoppers. I haven’t PE’d in years since not only did I meet my goal but
Surpassed it. I do not wish to gain anymore.

What worked for me may not work for you. Having gaps between clamps would not have worked
For me because I was looking for the best of both worlds and I found that forcing the first clamp as
Close to the pubic bone and tighten it cause a bulb to pop out at the base of the unit which forced the clamp
Closer to the pubic bone. The second clamp placed directly against the first forces more pressure
To the glands stretching the length of the penis as well, then the third makes the pressure more intense
Stretching the penis even more, then the fourth. I was stretching my unit and gaining girth as well.
For me, gaping the clamps did not give me the pressure I needed, in fact, it relieved pressure.
Everybody is different. I believe I have a pic of me glued double clamp in my thread.

If you glue the clamps, use marine silicon. That shit is strong glue and can take a lot of pressure.

I noticed the same thing as I seated the first clamp as tightly against the bone as I could, and with each successive clamp the shaft was squeezed further forward, which made me think this might actually lengthen my dick, which you confirmed happened to you.

Those who read the thread where this concept was put forward limit thinking about this toward it being a girth exercise by leaving gaps between clamps to allow girth expansion.

You and I close the gaps and had our units squeeze out the end and created what seems to be a length exercise my personal experience wad a sore tunics after I first tried it, which I never felt in all the months hanging for two hours a day!

How long did you do this for, and how much length did you get as a result?


Began December 2009 at 5 7/8" length and 5" girth.

As of December 5th 2012 7 3/8" BPEL and 6 1/8" base girth.

Going for the magic 8"x6"

And neither approach is wrong, just different.

They are my cable clamps, ill use them as I wish!


Began December 2009 at 5 7/8" length and 5" girth.

As of December 5th 2012 7 3/8" BPEL and 6 1/8" base girth.

Going for the magic 8"x6"

I would like to suggest we call this device, as I apply it, The Constrictor.


Began December 2009 at 5 7/8" length and 5" girth.

As of December 5th 2012 7 3/8" BPEL and 6 1/8" base girth.

Going for the magic 8"x6"

Jeez I’m not saying anyones approach is wrong, you can multiple clamp your dick anyway you like and if it works then great.
My point was that the cock coffin idea originally discussed by xeno was a girth exercise designed to take advantage of the extra expansion seen next to a clamp normally at the base and recreate that expansion along the shaft using multiple spaced out clamps.

Stacking clamps to force more length and or glans expansion is perfectly legitimate but was not the intention of the original idea.

Since a-unit posted in and referenced xenos original posts I thought it was worth clarifying for anyone who hadn’t read them.
Having said that this is a-units thread and he can experiment with multiple clamps in anyway he chooses.

If you’re stacking clamps then the whole concept of creating multiple strain ellipses is irrelevant and that was the whole point of the cock coffin idea.

I would hope that anyone who’s read the original threads which discussed this would understand what I’ve been trying to say.

Oh and the “how much have you gained” comment was a real cheap shot thanks for that.

Originally Posted by xenolith
Glue ‘em all together to make a CCCC (Cable Clamp Cock Coffin)

" Just clamp every other clamp. The name isn’t exactly confidence inspiring…any suggestions for something a bit more positive?"

Strain ellipse mechanics adjacent to clamps

I hope that’s clear.

Capernicus, my apology.

I was joking about doing it my way, and appreciate our genuine desire for clarification regarding the original coffin concept.

The PE community needs facts, history and guidance in matters such as this, and hopefully we can all provide such as we strive for our goals.

Sometimes the nuance of humour gets lost in posts.

Again, my apology.


Began December 2009 at 5 7/8" length and 5" girth.

As of December 5th 2012 7 3/8" BPEL and 6 1/8" base girth.

Going for the magic 8"x6"

Originally Posted by a-unit
Capernicus, my apology.

I was joking about doing it my way, and appreciate our genuine desire for clarification regarding the original coffin concept.

The PE community needs facts, history and guidance in matters such as this, and hopefully we can all provide such as we strive for our goals.

Sometimes the nuance of humour gets lost in posts.

Again, my apology.

Thanks for clarification on the issue mate but no apology needed from you.
Looking forward to your experiments.

Originally Posted by marinera
Many of the things posted by Xeno should be take* with more than a grain of salt.


The polite thing to do would have been to state that YOU take what I post with more than a grain of salt.

Whether you believe it or not, I’ve never lied about anything that I’ve posted on this forum.

xeno


originally: 6.5" BPEL x 5.0" EG (ms); currently: 9.825" BPEL x 6.825" EG (ms)

Hidden details: Finding xeno: a penis tale; Some photos: Tiger

Tell me, o monks; what cannot be achieved through efforts. - Siddhartha Gautama

There wasn’t any implication about lying, but the ‘experimental’ nature of many of your posts. For this specific topic :many clamps spaced can look like a good idea; what I think many people will find though, more probably, is that any clamp added will decrease the pressure applied by the remaining clamps.

Top

All times are GMT. The time now is 06:09 PM.