Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

CLAMPING Everything You Ever Wanted To Know

I’m having a lot of trouble getting over 6.25” girth while clamped. I can only gain about 0.25” while clamped, I’ve never been able to get more. I just started trying some clamped bending, which is what got me up there in the first place, but I can’t get over it. I’ve really only ever tried one set of bends while clamped. I don’t do two sets because I have to warm up first, and after I’ve done one set, I don’t want to do another because I don’t want to overdo it.

Does anyone have any advice?

I think I remember Peterbuilt saying that he did clamped bends and got some good gains. I remember him saying in particular that as he did it more and more, the amount he was able to increase per session went way up. If you’re reading this Peterbuilt, how long did this take exactly and do you have any advice?

Thanks!

Mick

If you clamp for 10 minutes and get a 0.25 increase,

and clamp for 20 minutes and get a 0.50 increase,

do you clamp incorectly ? should I go for 20 minutes ? seems long to me…


~01/01/2006 -- 5 3/4" BPEL -- 4 3/4" Base Girth -- 4 1/2" Mid Girth.

~20/01/2007 -- 7" --- BPEL -- 5" Base Girth ------ 5" --- Mid Girth.

26/08/2008 --- 7" BPEL ------ 5 1/4 girth all around

Originally Posted by crashhex
Hopefully this can help you guys out. Wraping while clamping for a comfortable experience can be a pain in the ass. I used a foam type of tape and affixed it to the clamp itself, ending the need to take the time to wrap the penis itself. It’s very comfortable, practicle, cheap, and the engorgment is awesome.

Cheers,

Crash

So you don’t use any wrap on the penis itself.
Are you keeping on using this system?

Are there others guys using to wrap the clamp and not the shaft?
Thanks in advanced.

When I clamp I get good engorgement, like a rock. But when I remove the clamp almost all of the blood leaves my penis and I’m just about flaccid again. Whats not right, or is that normal?

Thanks

wpolo130 - that’s normal, it’s what you do when you’re in the clamp that counts.

With registration open again it’s a good thing this thread has been bumped..:)

All those considering clamping should read this thread. :nodding:


"Drilla Knows Ass" - Para-Goomba

Starter Pics/Clamping Pics

I got my clamps TODAY!!!!

I almost lost them cause the stupid mailman left them on the floor in the street cause it didnt fit in the mailbox!!!

I’m starting with this tonight.

:D :D :D :D

I am using an air clamp and getting erect and then putting the clamp on and squeezing the bulb, my erection girth increases by about 3/16”- 1/4”.

Then a couple of minutes later I measure but my girth does not stay the same or even stay at my normal erect girth.

I can only assume that I need to pump the bulb more and clamp harder.

I read in the earlier pages of this thread that it is OK to lose the erection but for me the girth decreases.

Clamping

The only ? I have is what kind of clamp do you guys use and do you have a picture of it so I can get one please and what kind of wrap do you use please help I need it I have been doing everything I can think of to get a bigger penis off and on for 3 years and not much has change thanks guys

Cable/Wench clamps or Air Clamps are the main tools used by clampers. Both can be bought here - http://www.peweights.com/products.html

One question I have is that every time I clamp I’ve been edging and kegeling to stay close to 100% hard. Is this the common practice or should I try it without edging and just do kegels, though I doubt I can keep it at 100% doing this for 10 minutes. More like 60-90%.

BG— hi…

A couple of questions:

Originally Posted by Big Girtha
I had been doing manual PE for about a year before I joined in Nov. 03

Are the starting stat figures listed in your sig the size you were when you started all PE, or are they the size you were when you joined Thundersplace?

Are the figures listed as your current stats up to date? If not, what are your current stats?

Also— what does your urologist think of the new chemically-induced-priapism enlargement technique?


Previously known as Mr. Fantastic

-------------------------------------------------------------

Size Myths in the Porn Industry


Last edited by Mr. Fantastic : 10-02-2006 at .

I have been doing PE for about 2 years, but I have recently started clamping using the cable clamps recommended by BG.

My question is how does one know when one has achieved the right “tightness” of clamping, such that blood is allowed to flow in (or be kegel ed in) but stopped from flowing out? I assume that there is a point at which the clamp is so tight that even the inflow of blood is prevented and thus defeating the purpose.

What are the visible signs, etc. That tell you that you are ideally clamped (to maximize engorgement and expansion pressure)? Should engorgement increase slowly but steadily during the 10-15 minute period that the clamp(s) are in place? What should it look/feel like?

Thanks,

JSM87

Originally Posted by JSM87
My question is how does one know when one has achieved the right “tightness” of clamping, such that blood is allowed to flow in (or be kegel ed in) but stopped from flowing out? I assume that there is a point at which the clamp is so tight that even the inflow of blood is prevented and thus defeating the purpose.

Clamping really is a art form and does take some expiermentation to get it down correctly. I don’t even fully understand yet what is causing my girth and length gains but I do a variety of clamping styles through out the day (I have lots of free time at the moment ;) ). I do what I call IC (Intense Clamping), MC (Moderate Clamping), and LC (Light Clamping) which is basically low pressure clamping for up to hours at a time sometimes (usually only for a half hour). LC is like girth wrapping and using PEWeights to maintain the girth after a clamping set for a long period of time (I don’t think LC is actually needed but since I have the time and I think it is safe enough then I might as well mess around a little with it). MC is simply moderatly clamping (now clicking all the way with the cable clamp), IC is of course clicking as many clicks as possible and/or using more padding/wrap and higher engorement levels when clamping down.

Now as for your question on what is the right clamping “tightness” level for clamping with a cable clamp/cuff I would say that no one truly really knows and it really is a individual thing (everyone is different, but there I believe there are certain tricks that can be used to achieve close to the perfect “tightness” every time easily for every clamping set — more on that later in the post). It is a subjective thing and takes determination and expiermentation to start achieving success and gains. I truly believe that from my expierence and knowledge that it is IC and MC that is what gives gains. LC is just a supplement to the clamping session (I could go into the reasons why one would LC but that would be a bit much for this post).

One trick that I just came up with (after tons of expiermentation) to achieve a nice “tightness” level easily every time for clamping is to take some foam grip material (I got mine from cutting off the foam grips on the 6 second abs handle bars, heh, you can also buy foam grips off ebay or somewhere else on the web). and then cut out 2 pieces of the foam grip material shaped to roughly the same dimensions as the sides of interior cable clamp sides. Then take some crazy glue and stick the non foam side of each of the 2 cut pieces of foam grip on to each respective interior side of the cable clamp being modified. I personally didn’t put any foam grip material on the bottom part of the cable clamp (the round part) but one might consider this if they try this idea for CS gains (I still think my CS is getting lots of pressure but I have my reaosn why I don’t want to put too much pressure there from past PE expierences dealing with the CS). I would go into more detail but I am already taking way to much space to answer these questions. I really need to work on my summerizing skills. ;)

It really really is important to use the right amount of wrap or material I’ve found to achieve that perfect “tightness” level. That is why I designed that little modification above to the cable clamp. For some reason a certain amount of padding is needed to use my cable clamp correctly for maximum expansion. Now if you were talking about the Air Clamp that is a whole different ball game and you would have to look at how to clamp sliglty different from my expierence.

One other thing I forgot to mention is you do not want to clamp down on a 100% fully hard erection. BIB talked about this and the reaons why not too and from my expierence he is ouviosly right. You just can’t get the same intensity and expansion from clamping down on a FBE (Full Blown Erection) then you could if you clamp at about 80% (80% as in your dick is fully engored yet just at the point where is about to get hard but is still pretty soft would be ideal). There are many tricks for this actually, you could also just get about a 50% erection clamp down moderatly and allow for slow expansion before getting to that perfect point then looking at some porn and kegeling and clamping kegeling clamping until the right intensity is reached for a clamping set.

Originally Posted by JSM87
What are the visible signs, etc. That tell you that you are ideally clamped (to maximize engorgement and expansion pressure)? Should engorgement increase slowly but steadily during the 10-15 minute period that the clamp(s) are in place? What should it look/feel like?

The visible signs are your dick should visiablly look and feel a bit bigger at the end of each clamping set. I notice that the first sets don’t cause too much expansion then the later sets are when the expansion really starts to show and feel. Yes engorgement should steadily and slowly increase during a 10 to 15 min set.

~~~~~~~~~~~~~~~

I hope I didn’t bore or confuse you too much man. I just wanted to help you by giving you some real info from my expierence that you could study and think about to help you out with your clamping. Good luck with the gains. :)

Thanks for the post LM,

Not boring or confusing at all, I’m looking for as much advice on this as possible right now given that I’m new to this, so I appreciate your help.

I have two more questions for everyone while I’m at it:

1. How do you know if you have clamped “too tightly” (I.e. Preventing any blood inflow)?

And

2. Would the ideal clamping tightness be as close as possible to that line (of being too tight) without crossing over it?

Thanks,

JSM87

1) Your cock goes cold, numb and starts to turn blue. Plus it’ll probably hurt with that kind of tightness.

2) Not necessarily, moderate clamping should suffice without having to get as close to the edge as possible. Imagine how far you click to get to that edge stage, then ease back 3 clicks. Somewhere in between these 3 clicks is your ideal clamping strength. It may differ from day to day depending on your mood.


"Drilla Knows Ass" - Para-Goomba

Starter Pics/Clamping Pics

Good advice drilla.

Top

All times are GMT. The time now is 11:07 PM.