Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Attention all Airclampers

12

Attention all Airclampers

I have been using the airclamp for about a year and a half now. I can honestly say, since using it I would probably never go back to regular clamping. I was wondering, for all those that have used it before, what are some of the different techniques you use to get MAX expansion while using the Airclamp?

I have found that I must pump more pressure every 5 seconds or so to keep my penis tight there? Doing something wrong?


Hanging through the year 2012. Check my log.

That doesn’t sound right. Have you ever checked it for air leaks. It almost sounds like you need to get a new one. Either that, or take an iron to the edges to see if that’ll work for you.

I have the Airclamp, but I`m not quite sure which I like better.

I feel that with a regular cable clamp I get to clamp much closer to my base than with the Airclamp.

Have you experienced good gains in these years? What about quality of erections?

Originally Posted by djam07

That doesn’t sound right. Have you ever checked it for air leaks. It almost sounds like you need to get a new one. Either that, or take an iron to the edges to see if that’ll work for you.

I will check for air leaks today. I didn’t understand the iron to the edges part..


Hanging through the year 2012. Check my log.

Renholder-

I have made .5 inches in girth since Jan. I had to go through alot of trial and error with the PE. In past times, I would get almost an inch and a half clamped with the airclamp on and then I’d go back and either over do it to get the expansion again one too many times or, after a session, I’d jelq it the wrong way. My erection level is insane because I do consistent kegels throughout the day.

Mister007-

I had a similar problem with my 1st airclamp. I was overdoing it one day and I started having to pump ever 5 seconds to get it going again. When I found out I had a air leak on one of the edges, I took a hot iron to the edges to melt it back together, getting rid of the leak. Give it a try, if it doesn’t work just buy a new one from Monty. It is worth and and in the worst case scenario, you get the new one and then repair the one you have gaining a spare. Hope it helps

By the way, which way are you using the air clamp?

I can’t find any air leaks.


Hanging through the year 2012. Check my log.

I use the airclamp the same way everyone else’s uses the cable clamps. There really isn’t that much of a difference in techniques, it’s just easier.

Check for air leaks by holding it under water, I guess?


regards, mgus

Taped onto the dashboard of a car at a junkyard, I once found the following: "Good judgement comes from experience. Experience comes from bad judgement." The car was crashed.

Primary goal: To have an EQ above average (i.e. streetsmart, compassionate about life and happy) Secondary goal: to make an anagram of my signature denoting how I feel about my gains

Originally Posted by mgus

Check for air leaks by holding it under water, I guess?

Hmm.. Is this safe? I don’t want to kill my air clamp!


Hanging through the year 2012. Check my log.

Just the clamp part, not the pump.

The same way one checks a bicycle tire. But I don’t own one, so someone else should chime in.


regards, mgus

Taped onto the dashboard of a car at a junkyard, I once found the following: "Good judgement comes from experience. Experience comes from bad judgement." The car was crashed.

Primary goal: To have an EQ above average (i.e. streetsmart, compassionate about life and happy) Secondary goal: to make an anagram of my signature denoting how I feel about my gains

Here’s my troubleshooting instructions:
If you remove the bladder from the sheath notice how it is folded so you can get it back in with the same orientation. Slide the sheath up to pump and valve so the bladder is exposed only. This will keep the sheath dry.

Put enough water in a sink or bowel to dunk the bladder into.

Submerge just the bladder and work out any bubbles trapped in the material if you dunk the unit without taking the bladder out of the sheath.

Pump once or twice but don’t pump hard as the bladder can burst.

If you see a steady stream of bubbles then that is where the leak is.

If there is no leak then the problem is in the valve assembly itself.

If the leak is around where the hose attaches, you won’t have much luck fixing that location.
If the leak is anywhere else around the edges then do the following.

If you have a bladder leak sometimes it can be repaired with a hot cloths iron.
Just touch the spot where the leak is and seal it off.
Don’t stay on it too long or you could melt the bladder.

Re-installation: (If you have cut the hose)
Fold the bladder so the felt pad is on the inside. Then fold again and start the bladder into the sheath.
When half way in, push the hose in and use a small blunt object like a crochet needle or anything to fish for the hose end through the sheath exit hole.
Goto *

(If you have not cut the hose.)
Fold the bladder so the felt pad is on the inside. Then fold again and start the bladder into the sheath.

* Pull the hose through and bladder until it fits back inside then work the second fold out of the bladder so it is only folded once. It should lay flat. Any folds other then the full half fold will cause future leaks. Pump and release to see if everything lays flat again.

Unit should be ready for use.


09-2003 BPEL:6.0x5.5

11-2004 BPEL:8.25x6.25 . . 9+ by Spring is the goal AIR CLAMP

Now BPEL:8 5/8 x 6 5/8 PE Weights

For anyone that still interested. I remember reading awhile back about keeping a consistent heat while clamped. I tried the clamp on today at 100% and kept my unique heat warming pad on me the whole time. My max expansion went up another .25 inch. I’ll stick with this method of clamping for as long as I can and try to keep anyone interested posted. I’m still looking for more ways to get better expansion if anyone wants to chime in.

Let’s keep this thread alive. I am very interested in the airclamp as a much more effective form of clamping. Anybody else have positive gains from this device?


6 X 5(Jun 2002) ----> 8 7/8 X 6 (OCt 2009) -----> 9.75 X 6.0 (Goal)

'I think you will find that the one thing all big gainers have in common is tenacity.' ~Bib

I, too, am very intrigued by the airclamp.


Short Term Goal - 7.75 BPEL

Top
12

All times are GMT. The time now is 03:47 PM.