X4 labs possible defective part

I have the X4 Extender Gold Premium and I was looking at the Automatic Spring-Loaded Tension Rods inside where the spring goes in and notice that the screw threads on one of them goes farther in than the other one, The one I think is normal has enough threading for only the rod that goes on top holding the spring in, and the other one has threading of about half an inch or more, and I think its leading to some grabbing and false tension amount, can someone please take a look inside both of there Automatic spring-loaded tension rods where the springs go in and let me know if this is normal or if the amount of threading inside are equal on each side, thank you.

Have you completely unscrewed them to have a look, the adjusters are threaded on both ends with opposite threads, one right handed one left handed, both sides should be the same.

Pictures would help.

Yes I have taken it apart to look inside both of them, and inside one of the Automatic Spring-Loaded Tension Rod is just enough threading just to screw in the bar that holds the spring in, and the other Automatic Spring-Loaded Tension Rod has way more threading, id say twice as much. I tried taking a pic but it doesn’t show very well

Can Anyone confirm by looking at there X4 Extender Gold Premium inside the Automatic Spring-Loaded Tension Rods, and look at both threads inside the hole that houses the springs and let me know if there is an equal amount of threads in each hole or if one of them has more threading then the other, thanks