Vacextender coldness and purple areas

Guys,

I finally got a vacextender 2 from a friend.am I excited? YES!

However, the instructional videos on the site let me download only one before the downloads stopped working (the one that showed how to assemble the vac extender), and my friend didn’t give me any instructions at all.

So I assembled it, guessed about the new base since I couldn’t get to the video, and wore it for about 45 minutes at a stretch I felt comfortable with. At that time, things started to feel a little numb down there, so I took it off. The tip was VERY cold, and there were purple blotches, albeit faint, around my peehole.

So I have 3 questions:

1. Is this coldness and are the purple areas normal?
2. How do you determine what stretch you should adjust this to? I could’ve probably stretched further, but when I did it started to feel uncomfortable. Not awful, but uncomfy.
3. Am I doing anything wrong?

Thanks!
P

I think you didn’t get the seal right. There’s air left in the cylinder.

If so, how do I when I have the seal right? I followed what I saw in the video.I.e., pushing the penis head into the cap while rolling the tube down enough so the vacuum hole it exposed and air can get in.

Also, I can find no mention at all on the site of what the constriction sleeve is for. There’s a video on how to put it on, but none on what you then use it for. Would this prevent the coldness and fluid build up?

I’m getting ready to leave on a 8-hour trip and it’d be nice to wear the vacads (I bought the whole package) but now I’m a little scared..

Thanks for your help mister007.

The constriction sleeve does almost completely remove the fluid build up, I find that the unit gets cold so I take mine out every hour massage it then put it back in.

These are the instructions for the constriction sleeve :

Autoextender Penis Enlargement Device

Hope this helps

Thebishop

You don’t want to let air in, it’s the other way around. Push your glans all the way in, then roll back the seal and you’ll hear a little “pfft” as the last of the air goes out, now roll back the seal while having the glans all the way in. DON’T let air in.

I wore it harder and longer than before a while ago, while getting all air out. Result: a small blister right where the vacuum hole is. I guess that proved that I got all air out, but it’s better to wear the constriction sleeve and not get blisters.