Measuring your peice.

I was wondering how to measure your cock correctly, or what you would believe the best way to go about it might be. I used to measure for length by going from the side of my cock. (I get longer measurements that way) Now I do it from the top and that is how I got my measurements that I’ve entered in the PE data base and my sig. Also for girth I measure at about 80% - 90% hard, right at the base. Is this the way every one else does it? I just want to make sure I’m accurate with the data I’m entering. (If I measured from the side then my EL is 7.00”. And for EG, if I measure from the middle of the shaft instead of the base I’m right at 5.1” girth.) Comments anybody?

Also wanted to add to it that when measuring FL I hold it up at a 90 degree angle, and do not bone press. If I measured it just how it hangs it would be closer to 5” FL. 5” FL just sounded to long to be correct to me so I just held it in my hand to measure at a 90 degree angle. Is that the way you all do it? Just wondering.

Not even a single reply.. Come on guys, any one have any input at all?

I believe that most measure length bone pressed right angles to the body along the top middle of the penis. Girth should be measured mid shaft using paper or measuring tape but not string since it gives a bigger and false girth. If I measured girth at base I would already be at my goal of 6 inches. But mid shaft I measure 5.5 so I’ve 0.5 inch to go. Length bone pressed along the top I measure 7.8 inches.

Try using the search button… There are tons of threads on how to measure.

Wow, your almost sitting right at what my goal is. Good for you!! So your saying to measure my girth mid shaft and not base for EG. OK. So that makes my girth a little smaller, thats cool. So I’m guessing I’m doing every thing correct except the EG measurement. Ill change that right now to 5.1 on my stats. Any one else have any comments regarding this?