Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Measuring question.

Measuring question.

Hey Guys,

I’m new here and have been browsing for a while.just a quick question. Where do I find info on the correct way to measure. There must be a standard way.

You read this thread

START HERE ——-> NEWBIE ROUTINE <——- Important Newbie Threads/Info

In short, you get a ruler (not tape) and place it on the top of your shaft, barely touching the pubic bone area. This is non-bone pressed length.

Repeat, but push the ruler into your body as far as it will go, this is bone pressed length, and is necessary to confirm growth.

Girth is measured with a tape measure.

Welcome to Thunders.

Current PE status - Contemplating Retirement. STARTED - 6.75"x5.25" CURRENTLY 7.5"x5.5" - BPFSL - 7.25"

How to use the search button for best results. If you actually USE the search button, this is worth a read

Also, you’ll notice a slight difference in measurement depending on whether you’re standing, sitting, lying down. Standing seems to be the standard way to do it, but however you do it, just be consistent so you can track results accurately.

Most accurate I would say for consistent measurement would be a ruler pressed up against the pubic bone.

Do I need to straighten out the curve?

I mark my measuring device with a pen (just like my mom used to mark the door frame when I was growing up).
I use a piece of foamcore board instead of a ruler. I line the board up centered and mark where the tip is. Then I measure afterwards.
I use a cloth sewing ruler to measure girth.

As they say — read the appropriate wiki articles here.

Similar Threads 
ThreadStarterForumRepliesLast Post
Standardised measuring how to:pabsPenis Enlargement Basics2708-23-2008 08:43 AM
An Interesting Measuring QuestionbaywatchPenis Enlargement Basics206-12-2006 05:48 PM
Stupid Measuring QuestionMickPenis Enlargement Basics206-01-2003 10:53 PM

All times are GMT. The time now is 04:40 PM.