Girth Help

For sure, you can see it ha :)

I would ask one of the more experienced guys in the pump forum, my friend, my buys were mostly impulse and I just threw money at LAPDIST because people said they were of the highest quality. I didn’t really take the time to research prices and brands. People use all kinds of different pumps and cylinders I’d ask in the forum, and read.

Do you have before and after pics of your progress erect?

What kind of pump time and pressure should i use

No

You might notice it’s alot more intense that the bathmate pressure wise. I’d say start around 2-3 HG for sets of 10 minutes. Some people will say up the intensity further some people will say slow and steady wins the race I don’t really know

Will a 2 inch cylinder be ok even though my tip is 2.25 wide about 6.5 girth

No You will need a bigger cylinder, I suggest you go back to clamping maybe try to even out your girth more then try to get a pump, because some people report problems with balls getting sucked in with to big of a tube for their base girth, but this is out of my expertise, read about it. Which makes me question how in gods green earth did you fit the goliath properly at the base? Are you sure you were getting decent pressure?

Yes it should. Sizing the cylinder to your tip is very likely to make a bad fit. But ultimately this is your choice.

How does he fit his dick in there? Lube, just mash it in, half erect?

I assume by tip he means the rim of his glans?

Cylinders often are not exact and vary by around 1/8". And unless he used calipers to measure his glans he may be off. Sizing to 2.25" at his current girth would likely be a poor fit overall.

Or he can go with a VelSeal from Pumptoys and try a 2.25" with a large sealing gasket that can let him split the difference. His choice.

It wasnt difficult to seal the goliath it has a big base cushion, i just made sure i kept it pointed down and it wouldnt try to suck my balls in. It got plenty of pressure because after a good pump i measure 9x6.5 right out of the tube. If i over did it biggest was 7 inch girth but with that came a doughnut. Ill try to do more clamping and yes the ridge of my glans is right at 6.5, i ordered a 2x9.5 tube so we will see how it goes on monday, ill post pics of my progress before and after with the new tube. Thank you guys so much! Hopefully i can get my shaft to catch up with my glans!

In addition, ive tried cock rings after pumping but they dont keep it fully swollen, clamping is the only way it stays fully engorged

Good luck dude

If you’re 100% sure, you may have wanted to try the Vel Seal linked at 2.25” diameter like I said before. You may be able to make it work fine with lube, I suspect so but the cautious move would be the slightly wider tube with the big base seal.

I got the 2 inch cylinder in the mail today, i completely fill the cylinder at the base and top, mid girth still has a little air gap. It looks like ill need a 2.25 , i took pictures but i cant add them in here, perhaps someone can give me a link to a good air pumping routine, i did 8 minutes eith bathmate then 10 with the air pump at 4hg, no fluid build up or etc

Bathmate And Air Pump Combo Progress