Can I measure this way

It’s hard to explain but I can guide you. First grab your piece and with your right finger touch the right side of the shaft and then go down until you reach the rightside of the base and then press down until you feel the bone. That is where I measure from. Can you measure from there as a bone pressed measurement?

You can measure anyway you like for your own records, just be consistent. For BPEL measurements here, you’ll need to center the penis over the shaft for a legit measurement, though.

When measuring BP length, do you (if using a cloth tape) run the tape down over the glans till you reach the external urethral orifice (keeping the tape in skin-to-tape contact)? Or do you extend the tape straight out to where your eyes tell you the penis ends, so that the tape is over air (not keeping skin-to-tape contact)?

Also, when measuring BPEL, do you go for the value (I once did this and it made about an inch difference) just before orgasm (at the time, doing that, I was 7.25 to 7.5 from the base, not bone pressed, to the tip of the glans and my girth was 5.75. Otherwise I was 5.5 to 5.75 EL from base to tip and 5.75 EL girth. So, as you can see, that type of measurement sure makes a difference.

Always found it strange I had more girth (or equal) than length. Now, I’m in a turtling, decreased libido state I hope to revitalize via methods and info from this board. Great site for info!

Sadly, I need to take a vacation from porn to revitalize my own imagination (per board advice I looked up) so I won’t be measuring for a couple of weeks to see what I’m at now.

I get my very best possible erection, i.e. right before orgasm to measure with. I wouldn’t use a cloth tape measure for BPEL at all, but if you do, get it as straight as possible. Curving it to the urethral opening is giving yourself some unearned size. Get a wooden ruler at the drugstore and just use that. And don’t forget the bottom of the ruler has 1/8” of wood on it!