Best way to heat a cylinder in order to create curvature?
Hello Thunder’s Place community,
So rather than figure this out myself and waste time, money and all the effort involved in the inevitable trial and error, I found this website and thought to ask here to see if anyone else has successfully done this.
I would like to know the best way to incorporate a curve about 1/4 of the way up the length of a 12” cylinder with a angel of around 45 to 35+ degrees.
Heating the tube is obvious. But the best, most safe method for such a acute angel is something I do not know. The tools needed etc etc
For a while now I have used a 2D”x12L” tube that I cut a entry angel of around 45 degrees into, and it has helped me achieve a erection that rises closer to my body at about 60-65 degrees, rather than hang limp at or bellow 90 degrees (something that happens if one is lazy and lets the tube hang way past 90 degrees pump after pump, if you know what I mean). But now I would like to customize the cylinder more.
So does anyone have suggestion of the best method(s) of going about doing this?