Anyone have success evening out a cone shape

What was your technique? I’ve got a lot more base girth than near the glans, it seems my tunica is crazy tough and I don’t get very much expansion. I haven’t tried pumping, maybe that would help?

Thanks

I think just normal medium erection jelqing would help.

I have a baseball effect, always have and find it hard to get pressure starting at the base. I would think evening out a cone shaped should be easier.

I has a wicked cone shape a few years ago where my erection looked like a baby squash. I had a lot less girth from mid to head. So I mainly did mid to head work with wet jelqs and dry jelqs. Right now I have a 6” base with a .25 taper to the head which is 1.5” behind. Currently I am working on 3 one month programs to keep the base girth the same and decrease the taper up the shaft and head. I will post them in 2 months after I complete and tweak them a little more.

That means that the jelq starts from the middle to the top and completely ignore the lower part, ritght?.

Yes most of the jelqs will be from mid to head. If you wish you can do full wet jelqs after half wet jelqs so 150 mid to head then 150 full wet is really 300 mid to head.

Thank you so much, if you click on my pic and progress thread you will see that my girth under the shaft is smaller than the rest so this will come in handy.

Thank you man :) .

Mine got even worser:
FrontEg before PE: 4,3 now: 4,7
MidEg before PE: 4,7 now: 5,3
BaseEG before PE: 5,2 now: 5,9

Clamping rocked my BaseEG up!
Trying to even out my cone shape, I mostly did Ulis at the midshaft, but my FrontEG is far behind.
It seems like the most gains are at the point where my dick gets squeezed either by Uli or a Clamp.

So lately I experiment with Ulis nearly behind the glans, it’s a bit tricky but I can already see some good temporary expansion there.

I’ve taken notice that when jelqing at a higher % like 70-80% I gained base girth, I’m guessing it applies pressure in both directions of the fingers. However when I would kegel and clamp my fingers closed then relax before jelqing this didn’t happen. You can also try clamping midshaft and applying tugging pressure behind the clamp. When you do ulis behind the head be very careful and monitor pain carefully. When you let go of the uli and your glans or your erection deflates a little give yourself atleas 1-2 minus before attempting this again.

5.2 4.7 4.3
5.9 5.3 4.7
Wow you’ve made a lot of progress on your taper. Keep up the good work!

Thank you :) but my FrontEG has to be worked more ..

Because of my taper I never had the feeling that jelqing really expands my tunica. It gives me a good flaccid and bigger (and therefore harder) CCs, but I always had the feeling that while doing the jelq move, that the pressure slided away under my hands because of the coned shape, so that the expansion at the front of the shaft was not satisfying.

Ulis, Clamping and Pumping are my weapons of choice against the tunica.
I will also start trying some Bends behind the glans and to the mid. I believe bends can stress the tunica very good.

I’m still iffy about bends seems like a dangerous move over time.

I had the same problem with jelqs before. What helped me a lot was to tighten my grip up the shaft to keep pressure equal. Give it a try!

yeah I know :D when I did Ulis the first time at the upper shaft, it ached for a few days because the tunica in this area wasn’t prepared for the high pressure.
You should do this carefully, like you were a newbie again!

I tried once, but decided to spent my time more on Ulis. But I think I will give it a try again :)

You have given me a good idea!

Good post I have the same concern. My girth starts at 5.25” behind the head and goes to 6.25” at the base.

I’ve done quite a few bends trying to work the tunica and a lot of mid erection jelqs. I’ve gotten gains in girth except near the glans. I guess maybe it is just slower to react in that area. Time will tell.

Thanks

I heard of baseball bat effect, but baseball effect? Sounds nasty… (: