The big penis and mens' sexual health source, increasing penis size around the world.
I do restric the lenght in my cylinder as well (see pic).
There is a formular to determine the lenght one has to restrict his cylinder to: BPEL * 0.85. Were does this formular originate from? I did not find any proper theory elaborating restricting the lenght of the tube, as well.
Is this a viable method for girth? Because if it is, would be good due to not having to buy a wider tube. Genuine question/bump.
Each of these ideas we can find on thunders and incorporate are so helpful. I just try each thing a bit and find what works. It’s awesome. Thank you
Quick question, if you get a cylinder your exact (or slightly smaller) erect girth size, to work on gaining length, will it have a negative affect on your erect girth over time?
Should you have two different diameter cylinders if you want to gain both length and girth?
Quick question, if you get a cylinder your exact (or slightly smaller) erect girth size, to work on gaining length, will it have a negative affect on your erect girth over time?
I’ve done exactly this for several years and there were no obvious negative effects to my girth. Length came very easy for me with this method. Though girth has always been difficult if not impossible for me to gain, I have not lost any.
-Stay safe
Thanks 114, I wasn’t sure if I would lose girth if I got a smaller cylinder that restricted it slightly.
If I want to pump to gain length (restricting the girth somewhat), and my EG is 6”, should I order the LeLuv 2” round flange cylinder, or the 2 1/8”? The base diameter is 1/4” smaller for a better seal, and I thought the 2” cylinder would be good, just wasn’t sure if 1 3/4” would be too snug at the base, or if that’s what I would want for the restriction to force length growth?
If I want to pump to gain length (restricting the girth somewhat), and my EG is 6", should I order the LeLuv 2" round flange cylinder, or the 2 1/8"? The base diameter is 1/4" smaller for a better seal, and I thought the 2" cylinder would be good, just wasn’t sure if 1 3/4" would be too snug at the base, or if that’s what I would want for the restriction to force length growth?
I would go with the 2". A little snug is what you want if you’re length pumping. You’ll want most of the force in the tube applied to the glans side half of the shaft to get the stretch we’re after.
Unless your shaft is perfectly cylindrical the 2 1/8" might be a little big.
-Stay safe
Thanks 114, good to know.
If I am close to 7 1/2" NBPEL should I get a 9" or 12" cylinder? An additional 1/2" would be plenty, just not sure if a 9" cylinder is enough. With the round flange at the base it’s probably closer to 9 1/4"+.
Go for the 12 if you can. Won’t hurt or change anything. I started with a 9 and eventually got to end of it and had to get a longer tube anyway. Better to just buy it once and be done, I think.
-Stay safe
Got the 2" x12" cylinder, wow, definitely long. I know it’s good to have something to grow into, but I think the 9" would have been fine. The cylinders have the round flange, which adds another 1/4" plus before the measurement markings actually start, so the overall length is more like 9 1/4" +.
I’ll have to give it some consideration, but I may sell the 12" one. I also have another LeLuv 2 1/4" x 9" WIDE flange cylinder that I’m interested in selling. Just going through some trial and error on sizing, think I finally got it figured out. 🤔